Polyplanar IXM-10 XM Manuel d'utilisateur télécharger pdf (Page 7)

1352 Charwood Road, Suite D, Hanover, MD 21076 Tel (410) 761-4000 Fax (410) 761-6274

www.polyplanar.com

Scan Mode

[2] Presets.

Set favorite channels by holding down one

of the Preset buttons (1-6) for 2 seconds.

[3] Tune Up/Down. Use Tune Up and Down to change channels.

[4] Source. Push “Source” until XM shows as the audio source.

[5] Band. Select preset banks XM1, XM2 and XM3 by pushing the “Band”

button. Store up to 6 presets per “Band”

[6] Scan. Scans up through the channels. Stays for 10 seconds and then

increments to the next channel. Push “Scan” again to exit scan mode.

[7] Display. Push the “Display” button to cycle through “Main, Artist, Song

and Category.

[8] Category. Push the “Category” button to cycle through the XM content

categories. The first time will display the current category. The display will

show “CA” and each press of the “Category” button will move to the next

category. Category mode will time-out after 15 seconds of idle. To tune to

a station within a category, use the UP/DOWN tuning buttons.

Band Signal Strength Preset #

1 2 3 4 5 6 7 8 9

Pas de commentaire

Polyplanar IXM-10 XM Manuel d'utilisateur Page 7